What the hours cover

Pull the sensor, clean or replace it, and verify the microamp signal with the burners lit.

The math at the book numbers

(billable hours × loaded labor rate × labor factor) + (material cost × markup), rounded to the nearest $10

The labor factor is the overhead multiplier divided by one minus the target margin. At 1.4 and 22 percent that is 1.79.

Flame sensor. 0.5 hours × $135 × 1.79 is $121.15 of labor. $18 of material × 1.35 is $24.30. Together that is $145.45, which is under the $175 minimum charge, so the Good price is $175.

Better is the Good price times 1.25 and Best is times 1.55. Same job done better, not a different job.

Same job at three labor rates

Tier$110 rate$135 rate$165 rate
Good$175$175$175
Better$175$180$220
Best$190$230$270

All three tiers at each rate. Everything else left at the book numbers.

What moves this number

  • A low signal that is not the sensor. Dirty burners or a bad ground read the same way.
  • Cracked porcelain. Cleaning will not fix that.
  • Sensors that are part of a burner assembly on some furnaces.

Not in this price

The diagnostic, burner cleaning, and a control board if that turns out to be the problem.

The full breakdown is in the guide: How to Price an HVAC Service Call.