For Electricians and HVAC · Free · No Email Required

Flat Rate Price Calculators

Pick a job. The book hours and material are already filled in. Put in your own labor rate and get a Good, Better and Best price you can quote.

How every one of these works

A flat rate price is not a guess and it is not what the guy down the street charges. It is one calculation, and every calculator on this page runs the same one:

(billable hours × loaded labor rate × labor factor) + (material cost × markup), rounded to the nearest $10

The hours are real time on site, start to clean-up. The material is what you pay at the supply house. The labor factor is your overhead multiplier divided by one minus your target margin, and it is the part most contractors leave out. The minimum charge catches the small repairs that would not cover a dispatch on their own.

Each calculator opens at the book numbers for a Philadelphia metro shop at a $135 loaded rate. Change the rate to yours and watch what moves. Labor heavy jobs move a lot. Parts heavy jobs barely move. That is worth knowing before you raise your rate, and before you decide which jobs to chase.

If you do not know your rate, start with the labor rate calculator. Every price here depends on it. Want every job on one page? The electrical, HVAC and plumbing pricing guides lay them out as price lists.

Electrical

Service and panel work, the code add-ons that ride along with it, and the rewire units.

HVAC

The repairs you run every week, the tune-up, and the changeouts by size and fuel.

Where the numbers come from

Every hour and every material figure in these calculators is published, with the reasoning behind it, in one of these guides:

Common questions

Are these prices right for my market?

No, and they are not meant to be. The starting numbers are what the formula returns for a Philadelphia metro shop at a $135 loaded rate. Put in your own rate and your own material costs and the price becomes yours. Quoting somebody else's market is the fastest way to lose money or lose bids.

What is the labor factor?

It is what turns your loaded labor rate into the rate you have to bill. Take the overhead multiplier and divide it by one minus your target margin. At 1.35 and 20 percent that is 1.69, so a $135 loaded hour bills at about $228.

Where do the hours and material come from?

From the pricing guides on this site, which were written from the Tradesman Office price books. Every calculator links to the guide its numbers came out of.

Is this the price book?

No. This is a couple dozen lines worked in the open so you can see how a flat rate number gets built. The price books carry the full catalog for each trade with all three tiers on every line, in a spreadsheet you own and edit.

More free tools

See all free tools →